Skip to content

Attendance and devices

Last updated: 13 November 2026

The attendance module is optional. Once it is on, Utared records check-in and check-out from your terminals or by manual entry, and works out lateness and overtime by your rules.

Turn attendance on and set the rules

  1. Open Settings and, in the Leave and attendance group, turn the attendance switch on.
  2. Open Attendance rules and set: the working week, a fixed or flexible schedule, the grace minutes (0 to 120), Ramadan hours, and the departments that earn overtime.
  3. The side menu then shows, under Attendance: Daily Attendance, Sites and Devices.

Connect a terminal

  1. Open Devices and add a device: name, vendor, time zone, status and the device's serial number, which must be unique.
  2. The vendor options are: ZKTeco terminal (direct push), ZKTeco BioTime (cloud bridge), or manual / supervisor entry.
  3. On the terminal itself, open the communication settings, then Cloud Server Setting (ADMS), and enter the server address and port shown on the set-up card of the device page.
  4. Once connected, the terminal sends punches by itself and they appear in Daily Attendance.
Important: the user number on the terminal is matched to the Biometric PIN field in the employee's file. If nothing matches, the employee ID is tried. Make sure the numbers agree before you start.

Manual entry and reports

  • Record attendance: enter or correct a punch by hand when a terminal is down or someone works off site.
  • Attendance report: days present, absent and late for each employee over the period you choose, with export.

How attendance affects payroll

Recorded overtime hours and absence days go into the pay run, priced at the overtime rates of the pay schedule. Review attendance before you create the run. See Running payroll and the WPS file.

Was something unclear? Contact us